Mixer chain of signal

Recreations of epic sounds using our products

Return to “Epic Sound Design & Recreation Forum”

[You can only see part of this thread as you are not logged in to the forums]
F Gabba L Belardi
Thu Feb 22, 2024 6:07 am


Mixer chain of signal

Hi there,

I have a 3osc bass that goes to one mixer Ch. Which is routed in parallel to 3 other Ch’s. Anyway it’s complicated, much routing…

I wanted to pactherise the whole thing, however after a couple of hours and some 15 effects later, I was not able to recreate the sound.

My question is (I have read the manual but I hoped it was more exhaustive) what is the actual wiring of the signal audio from the vst output to the master input?

Are the effects running in parallel? ( I guess they do?)

Is the fruity balance a substitute for the fader in the mixer Ch. Or is there a more appropriate tool?

I was using fruity balance to imitate the routing within patcher (of what I did in my mixer channels in my original set up) or is there a better way?

Also, what would you use as a co troller for signal level for automations within patcher?

Thanks so much

Return to “Epic Sound Design & Recreation Forum”