Problem: FG Microwavable - Tone warping

Hello,

First of all, if this post does not belong under this topic, let me know I can move it.

I have a problem. When I use FG Microwavable I noticed that the tone is warping while it plays, and starts at a different tone every time the synth starts.
The plugin starts with the following settings:

- 1ModWhl - Filter Cutoff
- Aftertouch - LFO Amount
- 1 Modwhl - Master Level

Troubleshooting:
- I made sure all filters were off in Sawer.
- I made sure amp on LFO is off in Sawer.
- I turned off all effects (Chorus, Phaser, Delay, Reverb) in Sawer.
- Tried adjusting the Source of every MIDI Modulation Matrix to "---" and set Destination to all "Master Level" in Sawer.
- Tried turning amount know for all MIDI Modulation Matrix to off in Sawer.
- Checked my mixer, turned off all effects on the Sawer channel, its bus, and the master bus.
- Confirmed no automation clips were being used on any knob on Sawer.
- Started a whole new project with just Sawer using FG Microwavable.
- Tried a different Sawer Program (Example FG Mad Maxx), tone does not change every time I run it.

Still, the tone starts differently, and changes warps over time every time I push play, on a pattern or song.
I think this is related to the Midi Modulation Matrix. Even with all of this turned off, it continues to change and warp. The fact that if I change the program name to something else and problem goes away makes me believe this maybe a bug in Sawer itself.
Is this expected? Anything else I can do to troubleshoot?

System:
- Windows 10
- FL Studio 20.9.2 Build 2963 64bit
- Sawer 1.2.7 64bit