- DJI-FX.png (52.6 KiB) Viewed 322 times
You use the digits to select from one of six effects, the "FX" button to turn your selected effect on or off, and then the "COLOR" and "PARAMETER" knobs to control the effect as it would be on the mixer.
1. SPACE
An icy-sounding combination delay and reverb. Turning the "COLOR" knob to the right sends the mid and high bands into the effect, to the left sends the mid and low bands. The "PARAMETER" knob controls the feedback amount.
2. DUB ECHO
Two delays. Once again, turning the "COLOR" knob left or right sends different bands into the effect. However, it also affects the delay time for both delays, making one slower and the other faster. The "PARAMETER" knob also controls the feedback amount on this one.
3. SWEEP & GATE
Turning the "COLOR" knob to the right introduces a trapezoid-shaped band-pass filter (simultaneous low-pass and high-pass) whose center frequency can be controlled with the "PARAMETER" knob. Turning the "COLOR" knob to the left mixes in a simple gate whose threshold can be controlled with the "PARAMETER" knob.
4. NOISE
Filtered white noise. "COLOR" to the left for low-pass, to the right for high-pass. "PARAMETER" controls the volume.
5. CRUSH
A bitcrusher. Turning the "COLOR" knob in either direction will affect the rate and turning it to the right introduces a high-pass filter afterwards. "PARAMETER" affects bit reduction and the resonance of the filter.
6. FILTER
Filters the main signal. Controlled similarly to the "NOISE" effect. "COLOR" left for low-pass, right for high-pass. "PARAMETER" changes the resonance.
Hope y'all like it. I've been really inspired by all the cool stuff on here, making my own patches and wanting to post something for a while. I started this one like four months ago while I was still in the early days of learning so the signal chain might be needlessly complicated but it gets the job done imo. Take care and enjoy.