Request: Please add "sample start" control to FPC

Post your ideas and suggestions here

Return to “To Do”

[You can only see part of this thread as you are not logged in to the forums]
mdavisto
Fri Jun 15, 2018 6:18 am

2 x

Request: Please add "sample start" control to FPC

This feature would be a massive timesaver. Yes, it is possible to edit samples in Edison to chop off any leading space, but when you're building kits on the fly during a session, and you find a great sample that needs a trim, it takes you out of the flow of the process to then have to go edit it.

Being able to simply slide the sample start point over a bit right in FPC would be a godsend.

Falls under the category of "dear god please implement this I am dying over here".

Thank you.



Return to “To Do”