so imagine the Scenario:
Op1 is modulated by Op2. Meanwhile Op2 is set to be modulated by Op1. Now, Op1 is modulated by the already changed wave of Op2 and that should mean that Op2 should be modulated in a different way, because Op1 was modulated.
Okay, lots of similar words and all. I tried this and Sytrus handles it very well, no hard feedback if you don't turn the knobs above 20%. But my question is, which state of the Operators does Sytrus use to compute the result, when the result should change itself? Where is the cut or where did my train of thought go wrong?
find/exchange/discuss Sytrus presets & tips here
2 posts • Page 1 of 1
[You can only see part of this thread as you are not logged in to the forums]