Hi.
I have a Behringer Neutron and Crave. I can control either device directly (well, via FLS and my audio interface) but, when chaining the two together, I cannot control the second in the chain. I am transmitting midi data on different channels (same port). This is with either device first in the chain.
Is this likely to be a bad midi cable, or is there something else I should consider?
As an aside, without using extra gear (that I don't have unfortunately), is there a way to check what if any midi is being received by the second in the chain?
Thanks very much
Behringer Chaining Issue
Return to “MIDI Controller Support”
[You can only see part of this thread as you are not logged in to the forums]
Re: Behringer Chaining Issue
Sounds like you're using MIDI Thru to chain dev...