Simple 2-stage Barberpole Phaser

Share your Patcher presets here

Return to “Patcher - Presets”

[You can only see part of this thread as you are not logged in to the forums]
Randomized0000
Sat May 25, 2024 8:11 pm

x

Simple 2-stage Barberpole Phaser

(Updated file in comment below)

I made a very simple barberpole phaser to imitate the phasing effect used in t e l e p a t h's vaporwave music.

It uses EQ2, with two bands controlled by a set of LFOs (4x peak controllers). The first two LFOs directly control the two bands, modulating the frequency and the overall depth of the phasing effect. The last two LFOs gently rounds-off the effect on each band so that it sounds seamless.

On the surface is a dial to control the phasing speed. There are also three sliders for phaser depth, LFO base and LFO amount. Use the last two sliders to change the direction of the phaser, and the frequency region that the phasing takes place.
Attachments
Screenshot 2024-05-25 210645.png
Screenshot 2024-05-25 210645.png (75.93 KiB) Viewed 1372 times
n2-stage Barberpole Phaser.fst
(17.02 KiB) Downloaded 934 times
Last edited by Randomized0000 on Sat May 25, 2024 11:05 pm, edited 1 time in total.

Randomized0000
Sat May 25, 2024 11:05 pm

x

Re: Simple 2-stage Barberpole Phaser

Minor update with better labelling and slight a...
Attachments
n2-stage Barberpole Phaser.fst
(17.04 KiB) Downloaded 879 times

The-Doctor
Mon May 27, 2024 1:48 pm

x

Re: Simple 2-stage Barberpole Phaser

Can you recreate the Fall mode of a BOSS PH-3? ...


Return to “Patcher - Presets”